info@xy-masterbatch.com

CH|ENG

You are here：Home >News > Industry news

News

Feature Products

Industry news
Planetstrr
4 tips for injection mold installation
08/28/2018

The four recommendations for installing injection molds are as follows:
 
1. Preparation before installation
Confirm the cooling water circuit. The depth of the screw into the plate is 1.5-1.8 times the diameter of the screw. If the screwing is insufficient, it is easy to slip and there is a risk of the mold falling. Confirm that the operators, materials, tools, documents, equipment auxiliary machines, etc. required for production are complete.
 
2, the method of hanging mold
When the hanging mold is not horizontal, the mold cavity before and after the installation of the mold will have different steps, and for the production of sophisticated products, there will be problems such as poor concentricity, poor step, poor tooth shape accuracy and poor distance.
When installing the mold, we should pay attention to this problem. When the mold is pushed in and the hand can push the small position, stop the mold clamping. Loosen and tighten the lifting ring. The previous mode is used as the reference (because the front die has a positioning ring). When viewing the rear part, when the level of the front mold is the best, the mold cavity position is the same. Continue to clamp the mold to completion, but do not start the high pressure. it is good. (The first time the upper mold is closed, the high pressure must not be used first, and it is confirmed that the mold can be normal before starting the high pressure).
 
3, the method of screwing
The mold with low temperature, that is, the mold temperature below 50 degrees, can be clamped to the high pressure start. The front and rear molds are tightened diagonally. The 8 screws can be screwed out. When the mold temperature is above 50 degrees, the screws should not be tightened too tightly before the mold temperature is reached. After the mold temperature arrives, start the high pressure and tighten the screws diagonally.
The mold material will swell and increase in volume with increasing temperature. When the mold temperature is high, it is more obvious. If the screw is tightened before the temperature rises, it has a certain influence on the life of the mold and the accuracy of the mold.
 
4, the use of attached materials
When the mold thickness is not enough, it is necessary to add a template. When the mold temperature is high, it is better to install a heat shield between the plate and the mold. Whether it is a template or a heat shield, the flatness must be as small as possible.

If the flatness is large, the front and rear molds of the mold are not parallel, and there is a difference after the high pressure is closed, thereby affecting the product quality. When the mold temperature reaches the set value, the actual mold temperature is checked and a mold thickness adjustment is performed.


Welcome know our masterbatch for injection molding.

Previous article:Three coloring methods for injection molding

Next article:Three major problems related to the fading of plastic parts

About us

Products

Fast navigation

Contact Us

Tel： +86-531-8899 5327

Fax:  +86-534-376 0717

Email：info@xy-masterbatch.com

Address:Changjia Industrial Park, Qingyun County, Dezhou City, Shandong Province, P.R.China.

Planets

Copyright © 2017 Qingyun Xinyang New Materials Co., Ltd. All rights reserved.   备案号：鲁ICP备15028652号-2  鲁公网安备 37142302000114号